P/N: 55P5776 1 Converter Box for the T221 Flat Panel Monitor User's Guide
P/N: 55P5776 10 Fig. 9 Connection of the Dual Link signal cable and the converter box Connect the opposite end of the dual-lin
P/N: 55P5776 11 2.3. Setup Replace the covers on the back of the monitor and return the monitor to the upright position. Plug the power cords o
P/N: 55P5776 12 4. Troubleshooting This chapter explains what to do if a problem occurs while you are using the monitor. Only problems related
P/N: 55P5776 13Cause 2: The monitor has downlevel firmware that does not support a converter box. Action 2: Check the version of FPGA-LOGIC, as
P/N: 55P5776 14Cause 1: The converter box is not connected to the proper connector of the graphics card. Action 1: Connect the converter box to
P/N: 55P5776 15Appendix A. Product Specifications The following table shows the converter box specifications. They only apply when the converte
P/N: 55P5776 16Appendix B. Regulatory Compliance Federal Communications Commission (FCC) Statement IBM Converter box (P/N: 07N2230, FRU P/N:
P/N: 55P5776 17(Auszug aus dem EMVG vom 9.Nov.92, Para.3. Abs.4) European Union - EMC Directive This product is in conformity with the protect
P/N: 55P5776 18Union Europea - Normativa EMC Questo prodotto è conforme alle normative di protezione ai sensi della Direttiva del Consiglio del
P/N: 55P5776 19 Copyright(c) 2003 International Display Technology Co., Ltd. All rights reserved.
P/N: 55P5776 2Preface You will need a converter box if you are using an IBM T221 Flat Panel Monitor connected to a computer fitted with a graph
P/N: 55P5776 3Precautions for using the converter box safely and correctly DANGER To avoid electrical shock: l Never remove the cover of the c
P/N: 55P5776 4DANGER Sequence for connecting and disconnecting cables Electric current from the power cords and communication cables is hazard
P/N: 55P5776 5Contents 1. Preparation for Installation...
P/N: 55P5776 61. Preparation for Installation This chapter describes how to make sure that you have the required system configuration and comp
P/N: 55P5776 7 Fig. 3 Converter signal cable (length 65cm approx.) Fig. 4 User’s guide (this book) Fig. 5 Dual Link signal cable (length
P/N: 55P5776 8digital signal cable. If two digital signal cables are attached, disconnect both. Disconnect the digital signal cable from the co
P/N: 55P5776 9 Fig. 7 Connection of the converter signal cable and the monitor Connect the other end (marked "3") of the converter si
Comments to this Manuals