Ibm 48X-20X User Manual

48X-20X Internal IDECD-ROM DriveUser’s GuideIBMOPTIONSby IBM

2. Place or change the configuration jumper on the drive (and possibly makechanges to the configuration jumpers of other devices).If you do not unders

Front view of the driveRefer to the illustration to identify parts that might be referred to in theinstallation instructions.«1¬Headphone jack. Plug h

«4¬IDE connector. This is used to connect the CD-ROM drive to the IDE cable.«5¬DC power connector. This is used to connect the dc power cord to theCD-

or secondary. See the documentation that came with your computer todetermine if your computer supports this setting.Step 4. Setting the configuration

3. Check to make sure the alignment is correct; then tighten the screws tosecure the drive. Do not overtighten.Step 6. Attaching the cables to the dri

Step 8. Updating your computer configurationAfter you have completed the hardware installation, restart your computer.Usually, the configuration-setup

Use and care of the driveThis section includes instructions for the proper care of CDs and the care andoperation of your CD-ROM drive.Caring for a CDC

– Excessive vibration, sudden shock, or inclined surface– Excessive dustLoading a CDTo load a CD into a horizontally mounted CD-ROM drive do the follo

To load a CD into a vertically mounted CD-ROM drive do the following:1. Press the Eject/Load button.2. Look at the illustrations and compare them to y

Manually ejecting a CDIf you press the Eject/Load button and the tray does not slide out, turn off thecomputer. Straighten a large paper clip to form

Note: Before using this information and the product it supports, read the informationunder Appendix D, ″Product warranties and notices″ on page D-1.Fi

2. Insert an data CD into the CD-ROM drive. Many program CDs willautomatically start at this point. If the CD does not automatically start, goon to st

Appendix A. Customizing device driver configurationsettingsThis section contains information about how to customize and configure devicedrivers.Changi

5. Click the IDE ATA/ATAPI controller to open the tree.6. Double-click the device that corresponds to the port of your CD-ROM. Itwill either be Primar

Appendix B. Problem solvingComputer problems can be caused by hardware, software, or user error. Usingthe information in this section, you might be ab

connector at one end of the cable to the IDE port. Attach the CD-ROMdrive or any other slower device to the middle connector, and attach theother end

6. Check to see if there is a conflict between devices by doing the following:a. In the System Properties window, double-click CD-ROM to list theavail

The CD-ROM drive is not recognized by the operatingsystem, or drive performance is erratic.Some computers, such as IBM PS/ValuePoint models 6472, 6482

v Turn off the computer, unplug the cables from the electrical outlets for yourcomputer and all attached devices, and remove the computer cover. Check

v CDR-103The CD in the CD-ROM drive is not a High Sierra or an ISO 9660 format.The CD-ROM drive does not support this format.The connectors on the aud

Appendix C. Help and service informationThis section contains information on how to obtain online and telephonetechnical support.Online technical supp

ContentsAbout this book ...vSafety information ...viiPart 1: Installation and user’s guide ...1-1Appendix

For the support telephone number and support hours by country, refer to thefollowing table or to the enclosed technical support insert. Support phonen

Appendix D. Product warranties and noticesWarranty StatementsThe warranty statements consist of two parts: Part 1 and Part 2. Part 1 variesby country.

Date of Installation. The date on your sales receipt is the Date of Installation,unless IBM or your reseller informs you otherwise.During the warranty

Warranty ServiceTo obtain warranty service for the Machine, contact your reseller or IBM. In theUnited States, call IBM at 1-800-772-2227. In Canada,

IBM is responsible for loss of, or damage to, your Machine while it is 1) inIBM’s possession or 2) in transit in those cases where IBM is responsible

IBM Statement of Warranty Worldwide except Canada,Puerto Rico, Turkey, United States (Part 1 - General Terms)This Statement of Warranty includes Part

which IBM is not responsible. The warranty is voided by removal or alterationof Machine or parts identification labels.THESE WARRANTIES ARE YOUR EXCLU

Any feature, conversion, or upgrade IBM or your reseller services must beinstalled on a Machine which is 1) for certain Machines, the designated,seria

(including fundamental breach, negligence, misrepresentation, or other contractor tort claim), IBM is liable for no more than1. damages for bodily inj

acquired for personal, domestic or household use or consumption, then noneof the limitations in this paragraph apply.PEOPLE’S REPUBLIC OF CHINA: Gover

iv 48X-20X Internal IDE CD-ROM Drive: User’s Guide

If you purchased an IBM Personal Computer Machine in Albania, Armenia,Belarus, Bosnia and Herzegovina, Bulgaria, Croatia, Czech Republic, Georgia,Hung

Warranty Service: The following is added to this Section: During the warrantyperiod, transportation for delivery of the failing Machine to IBM will be

Applicability of suppliers and resellers (unchanged).The following replaces the second paragraph of this Section: Unless otherwiseprovided by mandator

NoticesThis publication was developed for products and services offered in the U.S.A.IBM may not offer the products, services, or features discussed i

will be the same on generally available systems. Furthermore, somemeasurements may have been estimated through extrapolation. Actual resultsmay vary.

48X-20X CD-ROM DriveFederal Communications Commission (FCC) statementNote: This equipment has been tested and found to comply with the limits fora Cla

This Class B digital apparatus complies with Canadian ICES-003.Avis de conformite a la reglementation d’Industrie CanadaCet appareil numérique de clas

résidentiel ordinaire afin de fournir une protection raisonnable contrel’interférence d’appareils de communication autorisés.Unione Europea - Directiv

Japanese statement of compliance for products less than or equal to 20 A perphaseD-18 48X-20X Internal IDE CD-ROM Drive: User’s Guide

About this bookThis manual contains instructions for installing, configuring, andtroubleshooting the IBM®48X-20X Internal IDE CD-ROM Drive. The manual

IBMRPart Number: 10K3783Printed in the United States of Americaon recycled paper containing 10%recovered post-consumer fiber.(1P) P/N: 10K3783

vi 48X-20X Internal IDE CD-ROM Drive: User’s Guide

Safety informationBefore installing this product, read the Safety Information.Antes de instalar este produto, leia as Informações de Segurança.Pred in

Antes de instalar este produto, leia as Informações sobre Segurança.Pred inštaláciou tohto zariadenia si pečítaje Bezpečnostné predpisy.Antes de insta

Part 1: Installation and user’s guideThe IBM®48X-20X Internal IDE CD-ROM Drive can read a compact disc (CD)containing approximately 680 MB1of informat