IBMProgram Directory forTivoli ADSTARDistributed Storage Managerfor VMVersion 3 Release 1.2Program Number 5697-VM3for Use withVM/ESA Version 2 Releas
Figure 5 (Page 2 of 2). Publications Useful During Installation / Service on VM/ESA Version 2.3.0 and higherPublication Title Form NumberVM/ESA: V
3.0 Program SupportThis section describes the IBM support available for Tivoli ADSM for VM.3.1 Preventive Service PlanningBefore installing Tivoli
4.0 Program and Service Level InformationThis section identifies the program and any relevant service levels of Tivoli ADSM for VM. The programlev
5.0 Installation Requirements and ConsiderationsThe following sections identify the system requirements for installing the Tivoli ADSM for VM progr
(Optional) IBM ACF/VTAM Version 3 Release 4 (5684-095) or later is required for SNAcommunications (3270 and APPC) between an ADSM client and th
If you choose to install Tivoli ADSM for VM on a common user ID the default minidisk addressesfor Tivoli ADSM for VM may already be defined. If a
Figure 8 (Page 2 of 2). DASD Storage Requirements for Target MinidisksMinidiskowner(user ID)DefaultAddressStorage inCylindersFB-512BlocksSFS 4KBlo
6.0 Installation InstructionsThis chapter describes the installation methods and the step-by-step procedures to install the Tivoli ADSMfor VM prog
For a complete description of all VMSES/E installation options refer to VMSES/E Introduction andReference.6.2 Plan Your Installation For Tivoli AD
continue with these procedures until a R/W link is established to the 51Dminidisk. What's Next?Beginning with VM/ESA Version 2 Release 4.0, Ti
Note Before using this information and the product it supports, be sure to read the general information under Appendix E, “Notices”on page 53.Thi
is what needs to be updated. You will need to replace the current DISABLEDentry for PRODID 5654A09A (Tivoli ADSM for VM) with the entry from the56
VMFINS276I VMFINS processing startedVMFINS199I VMFINS PRODLIST created on your A-diskVMFINS276I VMFINS processing completed successfullyReady
VMFINS2767I Reading VMFINS DEFAULTS B for additional optionsVMFINS276I VMFINS processing startedVMFINS261R Do you want to create an override
Note Complete this step only if you received message VMFREQ286W for any of the products that arerequired by Tivoli ADSM for VM: either IBM Langua
6.3 Allocate Resources for Installing Tivoli ADSM for VMUse the planning information in the 5654A09A PLANINFO file, created in the PLAN step, to:
2 Change the password for 5654A09A from xxxxxxxx to a valid password, inaccordance with your security guidelines.3 If you intend to use an SFS dire
Note: This must be done from a user ID that is an administrator forVMSYS: filepool.c Determine if there are enough blocks available in the filepo
3 Execute the profile to access MAINT's minidisks.profile4 If the Software Inventory disk (51D) was accessed R/O (read only) thenestablish wri
VMFINS2767I Reading VMFINS DEFAULTS B for additional optionsVMFINS276I VMFINS processing startedVMFINS261R Do you want to create an override
6.4.1 Update Build Status Table for Tivoli ADSM for VM1 Update the VM SYSBLDS software inventory file for Tivoli ADSM for VM.vmfins build ppf 5654A
Contents1.0 Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11.1 Program Descr
Admin Client on your system. The book also contains instructions formigrating a Version 2 ADSM system to Version 3.Tivoli ADSM for VM is now insta
7.0 Service Instructions RSU WarningIf applying a Tivoli ADSM for VM RSU (Recommended Service Upgrade) go to the instructions inAppendix A, “Apply
Build New LevelsThe build task generates the serviced level of an object and places the new object on a test BUILDdisk. Place the New Service i
5654A09A is the PPF that was shipped with theproduct. If you have your own PPF override youshould substitute your PPF name for 5654A09A.Use ADSM fo
Use ADSM for installing on minidisks or ADSMSFSfor installing in Shared File System directories.This command clears the alternate APPLY disk.10 Re
7.2.3 Apply the Service1 Apply the new service.vmfapply ppf 5654A09A {ADSM | ADSMSFS}Use ADSM for installing on minidisks or ADSMSFSfor installing
7.2.4 Update the Build Status Table1 Update the Build Status Table with serviced parts.vmfbld ppf 5654A09A {ADSM | ADSMSFS} (statusUse ADSM for in
Note If the $PPF files have been serviced you will get the following prompt:VMFBLD2185R The following source product parameter files have been se
2 Use VMFVIEW to review the build status messages, and see what objectsneed to be built.vmfview build7.2.5 Build Serviced Objects1 Rebuild Tivoli
You have finished servicing Tivoli ADSM for VM. Service Instructions 35
7.2 Servicing Tivoli ADSM for VM ... 287.2.1 Prepare to Receive Service ...
Appendix A. Applying an RSU Tape for Tivoli ADSM for VM Note You should first read through the RSU hard copy memo contained with the tape before c
Building New LevelsThe build tasks generates the serviced level of an object and places the new object on a BUILD disk. Placing the New Service
a If receiving the RSU from tapevmfins install info (nomemob If receiving the RSU from an envelope filevmfins install info (nomemo env rptfnum5 De
Use ADSM for installing on minidisks or ADSMSFSfor installing in Shared File System directories.This command produces an output file thatcontains i
VMFINS2767I Reading VMFINS DEFAULTS B for additional optionsVMFINS276I VMFINS processing startedVMFINS263I Processing product :PPF 5654A9A A
vmfapply ppf 5654A09A {ADSM | ADSMSFS} .Use ADSM for installing on minidisks or ADSMSFSfor installing in Shared File System directories.Messages VM
A.1.5 Determine RSU Service LevelThe service contained on each RSU constitutes a new service level. Use this service level when orderingcorrective
Appendix B. Disabling Tivoli ADSM for VMIf you are running VM/ESA Version 2 Release 4.0 and had previously licensed and enabled Tivoli ADSMfor VM 3
The 5654A09A PRODSYS file was created by VMFINS in the previous step.You need to update the CP system config file so that the next time you IPLyou
Appendix C. Moving Tivoli ADSM for VM to SFS Directoriesand Creating PPF OverrideThis appendix describes how to move Tivoli ADSM for VM into shared
1.0 IntroductionThis program directory is intended for the system programmer responsible for program installation andmaintenance. It contains info
Notes:1. The steps that follow help you determine the Tivoli ADSM for VM file pool space requirements, filepool enrollment, and SFS directory defi
set filepool userfilepool:create directory diriddirid is the name of the SFS directory you'recreating, such as the default names:create direct
Where vdev is the minidisk you are copying files from.If you are copying from SFS then substitute inthe SFS directory name in place of vdev. dir
2 Create (or modify as required) the Variable Declarations (:DCL.) section forthe ADSMSFS override area so that it resembles the :DCL. section assh
Appendix D. ADSM Installation Tape ContentsFile 1: INS 99 Tape descriptor file$$TAPE$$ VMSES Standard header file for SES format tapes5654A9A P
ANRSVM5 MODULE SVM moduleDSMSERV PROFILE Sample PROFILE EXEC for DSMSERV virtual machineDSMEXIT PROFILE Sample PROFILE EXEC for tape mount virtua
ANRVM CNTRL Control file containing the Version Vector Table levelSCRIPTS SAMPLE Server sample SCRIPTs ANRBAROC SAMPLE ANRUSRXA SAMPLE ANRUSRX
Appendix E. NoticesReferences in this document to IBM products, programs, or services do not imply that IBM intends tomake these available in all
54 Tivoli ADSM for VM Program Directory
Reader's CommentsTivoli ADSTAR Distributed Storage Manager Version 3 Release 1.2Your feedback is important in helping to provide the most acc
1.2 Important VM/ESA 2.4.0 InformationBeginning with VM/ESA 2.4.0, Tivoli ADSM for VM 3.1.2 is a pre-installed, optionally installable product on
Is this the first time your organization has installed this product? Yes No Were the people who did the installation experienced with the
IBMProgram Number: 5697-VM3 5802 6001Printed in U.S.A.GI1-548-
2.0 Program MaterialsAn IBM program is identified by a program number. The program number for Tivoli ADSTAR DistributedStorage Manager Version 3 i
2.2 Optional Machine-Readable MaterialThere are no optional machine-readable materials for Tivoli ADSM for VM. 2.3 Program PublicationsThe followi
One copy of the VM/ESA Softcopy displayable CD-ROM collection kit, IBM Online Library OmnibusEdition: VM Collection number SK2T-2067, will be inclu
Comments to this Manuals