Ibm PowerLook 2100XL User Manual

PowerLook 2100XL Operation Manual Thank you for purchasing the PowerLook 2100XL color scanner. With PowerLook 2100XL color scanner, you can

Chapter 2: Macintosh Installation This chapter describes how you can use your scanner with your Macintosh computer. Interface Card Installation (Fo

3. Connect the power cord to the scanner. And connect the other end of the power cord to a grounded power socket. 4. Turn on the scanner power.

How to Scan with Scan Frames Scan Frames are for use with transparencies and negatives. Scan Frames are thin, hinged rectangular-shaped plastic fram

Multiple Scanning Using the A3/ 35mm Slide Tray 1. Place the transparencies into the slide holders on the slide tray. 2. Lift up the A3 Scanner’

Chapter 3: PC Installation This chapter describes how you can connect and use the PowerLook 2100XL scanner with your IBM PC or compatible computer.

3. Connect the power cord to the scanner. 4. Turn on the scanner power. 5. Turn on the computer power. Hardware installation is now completed.

How to Scan with Scan Frames Scan Frames are for use with transparencies and negatives. Scan Frames are thin, hinged, rectangular-shaped plastic fra

Multiple Scanning Using the A3/ 35mm Slide Tray 1. Place the transparencies into the slide holders on the slide tray. 2. Lift up the A3 Scanner’

Chapter 4: Troubleshooting Tips The PowerLook 2100XL scanner was designed to provide a hassle-free installation and operation. However, should you

• Description of what you were doing at the time the malfunction or failure occurred. • Description of what you did to attempt to solve the proble

Contents Quick Start Guide…………………………………………………………………………………………...3 1. Unpack your Scanner……………………………………………………………………………….3 2. Connect the Interface C

Appendix A: Installing A SCSI Card If you are using a SCSI interface card with your computer and scanner, refer to the installation instructions pro

Checking the Terminators There should be two terminators in a SCSI chain: it is best to place the terminators at each end of the SCSI chain. PowerL

Case 2: Connect the scanner to a SCSI card that has another SCSI device attached to it.

Connect the Computer and Scanner Now that the interface card has been installed and all of the settings on the scanner and card are properly set, yo

Appendix B: Scanner Specifications Scanner Type Flatbed Interface Built-in SCSI II, one 25-pin connector and one 50-pin connector Scan Speed 10

Glossary Apple Compatible Driver An interface software module for applications other than Photoshop that support Apple scanners. Application Softwar

26 SCSI ID A unique number between 0 and 7 that identifies each device in a SCSI chain. The SCSI ID is set using a SCSI ID which found on most exte

Quick Start Guide This section serves as a quick reference to the connection and installation procedures for the PowerLook 2100XL scanner. 1. Unpac

5. Power Up a) Turn the scanner power switch on. When the Ready indicator is on, your scanner is ready to use. b) Turn on your computer 6. So

About this manual This manual is divided into chapters and appendices. The chapters give instructions on all aspects of installation, troubleshootin

Chapter 1: Getting Started Your PowerLook 2100XL scanner is extremely user-friendly. Hardware and software installation can be completed in a few s

 25/50-Pin SCSI Connector – Where you plug in the 25/50-Pin SCSI cable.  UTA Connector – A connector used to connect the optional UMAX Transparen

Prepare the Scanner Prepare your scanner for installation through the following simple steps:  Check and reset (if necessary) the scanner’s SCSI I

To reset the SCSI ID, do the following: 1. Make sure the scanner power is off. 2. Use a screwdriver to rotate the SCSI ID switch on the SCSI ID sw