Ibm Motherboard DJ800 User Manual download pdf (Page 37)

Chapter 3

Recommended Memory Configurations

The following steps are our recommended DIMM installation path

based on the number of DIMMS being installed (Remember to check

that the DIMMS are 1.8V Registered ECC or Non-ECC DDR2 DIMMs)

Memory Installation Procedures

1. Locate the Memory Bank on the Mainboard, where you will be in-

stalling the DIMMs.

2. Make sure the DIMM’s pins are facing down, and check that the pin

arrangement on the memory module resembles the one pictured

below.

3. Insert the module into the DIMM socket and press down evenly on

both ends firmly until the DIMM module is securely in place. (The

tabs of the DIMM socket will close-up to hold the DIMM in place

when the DIMM is properly installed on the socket’s bottom.)

4. Repeat step 1 to step 3 for all additional DIMM modules.

P.S If you only install one DIMM, please install on DIMMB4.

Module retaining notches

Socket retaining notches

3-7

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 55 56

No comments

Ibm Motherboard DJ800 User Manual Page 37