Ibm L190P User Manual download pdf (Page 17)

DEUTSCH

ENGLISHFRANÇAISESPAÑOLITALIANOJAPANESECOMPL & WARR

Auto Image Setup for DOS

To optimize the displayed image automatically in DOS, do the following:

If the monitor is in standby

mode (STANDBY ON), it

may automatically turn off while

you are waiting for it to warm up. If

this happens, switch off the

monitor and switch it on again

after a few seconds.

1. Turn on the monitor first; then turn on the computer.

If the message CHECK SIGNAL CABLE is displayed, or if nothing is

displayed, check:

• that the video interface cable is connected properly.

• the correct video adapter card is installed.

• the correct supported display mode is selected for your computer.

If you are using PC-DOS/V,

change to U.S. mode by

typing

‘CHEV US’

and pressing

ENTER at the command prompt.

2. Wait approximately 15 minutes, until the monitor warms up.

3. Insert the User’s Guide and Installation Files CD into the computer CD-

ROM drive.

4. Display the command prompt screen of the DOS full-screen display.

5. Type d:\ (change the drive letter to match your CD-ROM drive if it is not

drive D).

6. Type TESTPATD and press ENTER.

7. Select from the screen the number for the color or text mode you want to

set up.

8. Select from the screen the number for the video mode you want to set

up. You can repeat this process for as many of the color and video

modes as you need.

The size and diversity of the

dot pattern varies with the

screen resolution.

9. When the dot pattern appears, press the OSD Enter button at the

bottom of the monitor to display the initial OSD menu.

10. Use an Arrow button ( or ) to select the Image Setup icon

then press the OSD Enter button to access the function.

11. Using an Arrow button ( or ), select

AUTOMATIC and press the

OSD Enter button . This activates the

AUTO IMAGE SETUP procedure,

which will optimize the display settings with the provided dot-patterns.

The screen will flash off several times and you might notice small

changes to the test pattern.

12. When finished, the OSD main menu returns. Press the Exit button

to exit from the OSD.

13. Press the ESCAPE key to exit the test pattern program.

14. Type Exit at the command prompt to return to Windows.

If you use other operating systems, perform the appropriate Auto Image

Setup for those systems using instructions given in “Auto Image Setup for

Windows 3.1, Windows95, Windows 98, Windows NT, Windows Me or

Windows XP on page 16”

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 37 38

Comments to this Manuals

No comments

Ibm L190P User Manual Page 17

Comments to this Manuals

Related products and manuals for Monitors Ibm L190P