Ibm L190P User Manual download pdf (Page 20)

Manual Image Setup

Normally, you can complete the setup procedure using AUTO IMAGE SETUP;

however, if your screen image is still distorted after you perform

AUTO IMAGE

ETUP or the Installation CD does not run on your system, perform MANUAL

MAGE SETUP.

If the monitor is in standby

mode (STANDBY ON), it

might automatically turn off while

you are waiting for it to warm up.

1. Have your monitor turned on for about 15 minutes, until the monitor

warms up.

2. Display the image you most frequently use on the screen.

3. Press the OSD Enter button at the bottom of the monitor to display

the initial OSD menu.

4. Use an Arrow button ( or ) to select the Image Setup icon

and press the OSD Enter button to access the function.

5. Using an Arrow button ( or ), select

MANUAL, press and then

press again to access the Clock function

(see page 22) .

6. Use the Arrow buttons ( or ) to manually adjust the image (as

much as possible).

7. Next press the button to select Phase.

8. Use the Arrow buttons ( or ), again to tune the image to your

liking. To save, press the button two times.

9. When finished, press the Exit button to exit from the OSD.

You have completed the monitor manual image setup procedure.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 37 38

No comments

Ibm L190P User Manual Page 20