IBM T541A User Manual download pdf (Page 13)

Auto Setup for DOS

If the monitor is in standby

mode (STANDBY ON), it

may automatically turn off while

you are waiting for it to warm up.

If this happens, switch off the

monitor and switch it on again

after a few seconds.

1. Turn on the monitor first; then the PC.

If the message CHECK SIGNAL CABLE is displayed, or if nothing is

displayed check:

• that the video interface cable is connected properly.

• the correct video adapter card is installed.

• the correct supported display mode is selected for your PC.

If you are using PC-DOS/

V, change to U.S. mode by

typing ‘CHEV US’ and pressing

ENTER at the command

prompt.

2. Wait approximately 15 minutes, until the monitor warms up.

3. Insert the User’s Guide and Installation Files CD into the computer CD-

ROM drive.

You must use DOS when

you run DOS Auto Setup.

4. Display the command prompt screen of the DOS full-screen display.

5. Type d:\ (change the drive letter to match your CD-ROM drive if it is not

drive D).

6. Type ‘TESTPAT’ and press ENTER.

7. Select from the screen the number for the color or text mode you want to

setup.

8. Select from the screen the number for the video mode you want to

setup.

You may repeat this process for as many of the color and video modes

as you need.

The size and diversity of

the dot pattern varies with

the screen resolution.

9. When the dot pattern appears, press the OSD Enter button at the

bottom of the monitor to display the initial OSD menu.

10. Use an Arrow button ( or ) to select the IMAGE LOCK icon

then press the OSD Enter button to access the function.

11. Using an Arrow button ( or ), select

AUTOMATIC and press the

OSD Enter button . This activates the

AUTO SETUP procedure, which

will optimize the display settings with the provided dot-patterns.

The screen will blink off several times and you may notice small

changes to the test pattern.

12. When finished, the OSD main menu returns. Press the Exit button

to exit from the OSD.

13. Press the ESCAPE key to exit the test pattern program.

14. Type ‘Exit’ at the command prompt to return to Windows.

If you use other operating systems, perform the appropriate

AUTO SETUP for

those systems, also: see

Auto Setup for Windows 3.1, Windows 95, Windows 98, Windows NT or

Windows 2000, Windows Me or Windows XP.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 43 44

Comments to this Manuals

No comments

IBM T541A User Manual Page 13

Comments to this Manuals

Related products and manuals for TVs & monitors IBM T541A