IBM H80 User Manual download pdf (Page 182)

Step 5

Starting at the top of the following table, locate your symptom and perform the action

listed in the Action column.

Symptom Action

The power LED does not come on, or comes on

and does not stay on.

Check the power cable to the outlet. Check the

circuit breakers and check for power at the

outlet.

Ensure that the room temperature is within 60 -

90°F.

If you do not find a problem, record error code

M0PS0000 and report the problem to the

service organization.

The diagnostics are loaded and there was NO

beep heard from the system unit during the IPL

sequence.

Record error code M0SPK001.

The system stops with the Diagnostic Operating

Instructions displayed.

Go to “Step 6” on page 168.

The system stops with a prompt to enter a

password.

Enter the password. You are not allowed to

continue until a correct password has been

entered. When you have entered a valid

password, wait for one of the other conditions to

occur.

The system stops with a three-, four- or

eight-digit error code(s) displayed on the

console.

Record the error code(s) and report the problem

to the service organization.

The system login prompt is displayed. You may not have pressed the correct key or

you may not have pressed the key soon enough

when you were to indicate a Service Mode boot

of diagnostic programs. If this was the case,

start over at the beginning of this step.

If you are sure that you pressed the correct key

in a timely manner, go to Step 7.

The system does not respond when the

password is entered.

Go to "Step 7".

166 RS/6000 Enterprise Server Model H80 Series User's Guide

1 2 ... 177 178 179 180 181 182 183 184 185 186 187 ... 229 230

Comments to this Manuals

No comments

IBM H80 User Manual Page 182

Comments to this Manuals