IBM H80 User Manual download pdf (Page 51)

 Change Privileged Access Password

Set or change the Privileged Access Password. It provides the user with the

capability to access all service processor functions. This password is usually

used by the system administrator or root user.

 Change General Access Password

Set or change the General Access Password. It provides limited access to

service processor menus, and is usually available to all users who are allowed to

power on the server, especially remotely.

Note: The General Access Password can only be set or changed after the

Privileged Access Password is set.

 Enable/Disable Console Mirroring

Console mirroring is supported on serial port 1 (S1), serial port 2 (S2), and serial

port 3 (S3). When Console Mirroring is enabled, the service processor sends

information to all serial ports. The serial port from which console mirroring is

enabled is referred to as the

active port

. The

mirror port

is determined when

keyboard input is detected from one of the other ports. From this point on, the

service processor only sends information to the active port and the mirror port.

This capability can be enabled by local or remote users, providing local users

the capability to monitor remote sessions. Console mirroring can be enabled for

the current session only. For more information, see “Console Mirroring” on

page 74.

 Start Talk Mode

In a console-mirroring session, it is useful for those who are monitoring the

session to be able to communicate with each other. Selecting this menu item

activates the keyboards and displays for such communications while console

mirroring is established. This is a full duplex link, so message interference is

possible. Alternating messages between users works best.

Chapter 3. Using the Service Processor 35

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 229 230

No comments

IBM H80 User Manual Page 51