IBM x Series 200 User Manual download pdf (Page 53)

Installing options 45

Installing an adapter

Complete the following steps to install an adapter:

Attention: When you handle ESD-sensitive devices, take precautions to avoid

damage from static electricity. For details on handling these devices, see “Handling

static-sensitive devices” on page 39.

1. Review the information in “Before you begin” on page 38.

2. Turn off the server and peripheral devices and disconnect all external cables and

power cords; then, remove the side cover. See “Removing the side cover” on page

40 for details.

3. Determine which PCI expansion slot you will use for the adapter.

Note: Check the instructions that come with the adapter for any requirements,

restrictions, or cabling instructions. It might be easier for you to route any

cables before you install the adapter.

4. If you are installing a full-length adapter, rotate the front adapter support bracket

to the open (unlocked) position.

5. Rotate the rear adapter retaining bracket to the open (unlocked) position; then

place it over the rear of the server.

6. Remove the PCI expansion-slot cover. From the rear of the server, press in on the

slot cover. Grasp it and pull it out of the slot. Store it in a safe place for future use.

Attention: PCI expansion-slot covers must be installed on all vacant slots. This

maintains the electromagnetic emissions characteristics of the server and ensures

proper cooling of server components.

7. Remove the adapter from the static-protective package. Avoid touching the

components and gold-edge connectors on the adapter.

Adapter

retaining

bracket

Expansion

slot cover

Adapter

support

bracket

Adapter

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 151 152

No comments

IBM x Series 200 User Manual Page 53