IBM x Series 200 User Manual download pdf (Page 67)

Installing options 59

8. Reconnect the external cables and power cords, and turn on the peripheral

devices and the server.

Completing the installation

Attention: For correct cooling and airflow, install the cover before turning on the

server. Operating the server for extended periods of time (over 30

minutes) with the top cover removed might damage server components.

To complete the installation, you must reinstall the cover, reconnect all the cables that

you disconnected earlier and, for certain options, run the Configuration/Setup Utility

program. Follow the instructions in this section.

Note: If you have just plugged the power cords of the server into an electrical outlet,

you will have to wait approximately 20 seconds before pressing the power-

control button.

Installing the cover

The following illustration shows how install the server side cover.

Note: The illustrations in this document might differ slightly from your hardware.

Note: If you removed the support bracket assembly after you removed the cover,

reinstall it before you install the cover. See “Removing the support bracket

assembly” on page 42 for details.

Complete the following steps to install the server cover:

1. Clear any cables that might impede the replacement of the cover.

2. Install the side cover by placing it into position on the server. Close the cover

release latch to secure the cover in place.

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 151 152

No comments

IBM x Series 200 User Manual Page 67