IBM x Series 200 User Manual download pdf (Page 84)

76 Hardware Maintenance Manual: xSeries 200

To remove the system board, do the following:

1. Power-off the server, if it is on.

2. Unplug the server.

3. Remove the cover (see “Removing the side cover” on page 40).

4. Remove the front bezel (see “Removing the bezel” on page 41).

5. Remove the support bracket (see “Removing the support bracket assembly” on

page 42).

6. Disconnect the cables.

7. Remove the adapter cards and both adapter retaining brackets (see “Installing an

adapter” on page 45).

8. Remove the hot-swap hard disk drive cage (see “Hard disk drive cage” on page

73).

9. Remove memory modules (see “Installing memory modules” on page 52).

10. Remove microprocessors and/or terminator cards (see “Removing and installing

a microprocessor” on page 54).

11. Remove screws and lift the system board out of the server.

CD-ROM drive

Before you begin:

• Read “Safety information” on page 105.

• Review the information in “Before you begin” on page 38.

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 151 152

No comments

IBM x Series 200 User Manual Page 84